Table des Matières
Publicité
EN
SAFETY INDICATIONS
•
The present manual is an integral and essential part of the product and is to be delivered to the user.
Carefully read all warnings in the manual as they provide important information required to install,
use and maintain the unit safely. Keep this manual in a safe place for further consultation.
•
This unit must only be used for the purposes described in the present manual. The manufacturer
cannot be held responsible for any damages caused by improper, mistaken and unreasonable use.
•
Before using the machine, read this manual in its entirety or, at the very least, read the safety and set
up instructions.
•
The machine can be used only with ground coffee.
•
After having removed the packaging, make certain that the unit is not damaged in any way. If you
have any doubts, do not use the unit and contact a professionally qualified person. Always keep all
packaging (plastic bags, polystyrene foam, nails, etc..) out of the reach of children as they are a po-
tential source of danger and never loiter the environment with such materials.
•
The appliance is only to be installed in locations where its use and maintenance is restricted to trained
personnel.
•
The access to the service area is restricted to persons having knowledge and practical experience of
the appliance, in particular as far as safety and hygiene are concerned.
•
The machine must be installed on a horizontal surface at appropriate height so that the top of the
machine is higher than 1.2 m.
•
The appliance is not suitable for installation in an area where a water jet could be used.
•
The appliance must not be cleaned by a water jet.
•
The max inlet pressure value is 0.5 MPa.
•
The A-weigthed sound pressure level is below 70 dB.
•
To facilitate aeration of the unit, position the aeration portion of the machine 10 cm from walls or
other machinery.
•
Remember that to install, maintain, unload and regulate the unit, the qualified operator must always
wear work gloves and safety shoes.
•
Before turning on the unit make certain that the rating indicated on the label matches the available
power supply. The nameplate can be seen inside the machine when removing the water collection
tray. The machine must be installed according to the applicable federal, state and local standards
(codes) in force with regard to plumbing systems including back-flow prevention devices. For this
reason, the plumbing connections must be carried out by a qualified technician. The warranty ex-
pires if the characteristics of the power supply do not correspond to the nameplate data.
•
When installing the device, it is necessary to use the parts and materials supplied with the device
itself. Should it be necessary to use other parts, the installation engineer needs to check their suit-
ability for use in contact with water for human consumption. The installer must Make the hydraulic
connections respecting the rules of hygiene and water safety to environmental protection in force
10
Publicité
Table des Matières
