Ryobi RBV3000CSV Traduction Des Instructions Originales page 5

Table des Matières

Publicité

before operating.
Move the vacuum from side to side along outer edge of
debris. To avoid clogging, do not place the vacuum tube
directly into the debris pile.
Hold the motor higher than the inlet end of the vacuum
tube.
Always point vacuum tube downhill when working on
a hillside.
To avoid serious injury to the operator or damage to the
product, do not try to vacuum up rocks, broken glass,
bottles, or other similar objects.
Avoid situations that could cause fire in the vacuum
bag. Do not operate near an open flame. Do not
vacuum warm ash from fireplaces, barbecue pits, etc.
Do not vacuum discarded cigars or cigarettes unless
the cinders are completely cool.
TRANSPORTATION AND STORAGE
Stop the product, disconnect from the mains and allow
it to cool before storing or transporting.
Clean all foreign material from the product. Store it in a
cool dry and well-ventilated place that is inaccessible
to children. Keep away from corrosive agents such
as garden chemicals and de-icing salts. Do not store
outdoors.
For
transportation,
movement or falling to prevent injury to persons or
damage to the product.
MAINTENANCE
WARNING
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause possible injury, poor performance and may void
your warranty.
WARNING
Servicing requires extreme care and knowledge
technician. For service we suggest you return the
product to your nearest authorised service centre for
repair. When servicing, use only identical replacement
parts.
You may make adjustments and repairs described
here. For other repairs, contact the authorised service
agent.
After each use, clean the product with a soft dry cloth.
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
INTENDED USE
The product is only intended for use outdoors.
secure
the
product
against
The product is not intended to be used by children
or persons with reduced physical, mental or sensory
capabilities.
The product is intended for blowing light debris including
leaves, grass and other garden refuse. It is intended to
vacuum and lightly mulch debris as described above and
deposit it into the collection bag. It is not designed to suck
or vacuum water or other liquid.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
Injury caused by vibration. Always use the right tool for
the job, use designated handles and restrict working
time and exposure.
Exposure to noise can cause hearing injury. Wear ear
protection and limit exposure.
Injury from flying objects from the blow tube airflow or
vacuum exhaust if the bag is not fitted or damaged.
Wear adequate eye protection at all times.
RISK REDUCTION
It has been reported that vibrations from hand-held tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
Keep your body warm in cold weather. When operating
the product wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 104.
1. On/off switch and speed selector
2. Blow tube
3. High speed nozzle
4. Fan cover
5. Bag adaptor
EN
FR
DE
ES
English |
3

Publicité

Table des Matières
loading

Table des Matières