Abicor Binzel MAG RB/RP Mode D'emploi page 24

8 Maintenance and cleaning
NOTICE
• The specified maintenance intervals are guidance values and refer to single-shift
operation.
• Maintenance and cleaning work may only be carried out by qualified personnel (in
Germany see TRBS 1203).
• Check the coolant hoses, seals and connections for damage and tightness. Replace as
necessary.
• Always wear your personal protective equipment when performing maintenance and
cleaning work.
• Remove any adhering weld spatter.
• Ensure that all threaded fittings are tight.
8.1 Cleaning the wire guide
 Fig. 2 Mounting the wire guide on page EN-7
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide liner with compressed air, wear suitable protective
clothing, in particular safety goggles.
1 Unscrew the cable assembly (8) on the machine side and bring it into a stretched position.
2 Unscrew nut (5) and pull out liner (7) and replace it, if necessary.
3 Remove worn parts from the torch neck (2).
4 Clean wire conduit (3) from both sides with compressed air.
5 Slide adjusted liner (7) into wire conduit (3) and secure with nut (5).
6 Connect cable assembly (8) on the machine side with wire feed unit.
EN - 12
MAG Welding torches
BAL.0147 • 2018-11-09