Displaying The Powers Of Single Steps - Ducati Energia REGO 5 Manuel D'instruction

The user must indicate the desired status for every output relay: at the
end of the programming procedure, the controller will set all the
capacitor steps in the status requested. Operatively, REGO indicates
"r1" in turn with the status (which can be "On" or "OFF");
Ex.
press L or M to choose the status of the relay you want to set in the
manual operating mode; press the DATA key to display the status of
the subsequent relay. After viewing the status of the last relay, press
the DATA key to exit this function.

12.2 DISPLAYING THE POWERS OF SINGLE STEPS

Press DATA + L to access the relevant menu ("CP" will appear on the
display and L will flash);
when the L key is pressed, REGO will alternately display "C1" and the
value in kVAr associated with the first step.
Ex.
Every time you press the DATA key, the controller will show the powers
of the individual steps in sequence; after viewing the last step press
the DATA key to exit this function.
76