Powering Up For The First Time - Ducati Energia REGO 5 Manuel D'instruction

7) POWERING UP FOR THE FIRST TIME

The REGO regulator behaves differently the first time it is started up
since it will need the IL parameter (mains C.T. ratio ) to be set in order
to work; the regulator cannot be started up without setting this
parameter. On subsequent occasions it will utilize the previously
programmed parameter, unless the user wishes to change it.
As soon as the controller is switched on, 8.8.8. will appear on the
display for a few seconds and all the LEDs will light up to enable their
efficiency to be checked.
7.1 The first time the controller is powered the display will show
"IL" in turn with flashing "- - -" and remain in this situation until the
mains CT ratio is set;
press the L or M key to change the parameter and the DATA key
to confirm.
SETTING THE IL PARAMETER: for example, if the user has a
C.T. with a ratio of 200/5, the parameter to set must be IL= 40
(mains CT ratio);
Other examples: CT 300/5 IL=60; CT 350/5 IL=70; CT 400/5 IL=80.
7.2 Subsequently the controller will alternately display "FAS" and "0"
or "1";
at this stage the system will read and display the direction of the
incoming current from the C.T. (0 = direct / 1= inverted). It is only
an indication.
62