Light Emitting Diodes (Led) On Battery - Stihl HSA 66 Notice D'emploi

3 4
The light emitting diode (3) on the
charger comes on when the battery is
inserted – see "Light Emitting Diode
(LED) on Charger"
Charging begins as soon as the light
emitting diodes (4) on the battery glow
green – see "Light Emitting Diodes
(LEDs) on Battery".
The charge time is dependent on a
number of factors, including battery
condition, ambient temperature, etc.,
and may therefore vary from the charge
time in the "Specifications".
The battery heats up during operation in
the power tool. If a hot battery is inserted
in the charger, it may be necessary to
cool it down before charging. The
charging process begins only after the
battery has cooled down. The time
required for cooling may prolong the
charge time.
The battery and charger heat up during
the charging process.
AL 300, AL 500 Chargers
This charger is equipped with a battery
cooling fan which is audible when it is
running.
HSA 66, HSA 86
AL 100 charger
This charger waits for the battery to cool
down before starting the charging
process. The battery is cooled normally
by heat transfer to the ambient air.
End of Charge
The charger switches itself off
automatically when the battery is fully
charged:
Light emitting diodes on the battery
–
go off.
The light emitting diode on the
–
charger goes off.
The charger's fan is switched off (if
–
charger is so equipped)
Remove the charged battery from the
charger.
Light Emitting Diodes (LED)
on Battery
Four light emitting diodes show the
battery's state of charge and any
problems that occur on the battery or
power tool.
1
Press button (1) to activate the
N
display – the display goes off
automatically after 5 seconds.
The light emitting diodes can glow or
flash green or red.
Light emitting diode glows con -
tinuously green.
Light emitting diode flashes
green.
Light emitting diode glows con -
tinuously red.
Light emitting diode flashes red.
English
39