Getting Started; Unpacking; Hooking Up The System - Sony CDP-XB740 Mode D'emploi

Getting Started

Getting Started

Unpacking

Check that you received the following items:
• Audio connecting cord (1)
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert two R6 (size AA) batteries by matching the +
and – on the batteries to the diagram inside the battery
compartment.
Insert the negative (–) end first, then push in and down
until the positive (+) end clicks into the position.
When using the remote, point it at the remote sensor
on the player.
z
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4 GB

Hooking Up the System

Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
ANALOG OUT ANALOG OUT
(R) (L)
Audio input
Audio input
(L) (R)
: Signal flow
What cords will I need?
xWhen making analog hookups
• Audio cord (supplied) (1)
White
(L)
Red
(R)
xWhen making digital hookups
• Optical cable POC-15 (not supplied)
• Coaxial cable (not supplied)
CD player
To mains
Amplifier
To mains
White
(L)
Red
(R)