Machine Start And Stop; Stopping The Machine - Nilfisk SC400 9087313020 Instructions D'utilisation

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3. Connect the power supply plug (21) to the electrical mains.
WARNING!
Before connecting the power supply plug to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
4. To turn on the machine, turn the main switch (3) to "I".
5. Lower the squeegee (11) with the pedal (19).
6. Turn the knob (52) and select one of the programs according to the following table:
Selection Symbol
(53)
(54)
(55)
7. Press the solution flow push-button (57) to change the solution quantity. Green LEDs (58) indicate the flow quantity according
to the following table:
LEDs on (58) Symbol
8. To start scrubbing/drying, keep the hands on the handlebar (2) and press both the enabling push-button (59) and the brush
activation levers (60).

Stopping the machine

9. Release the brush levers (60) and the enabling push-button (59).
10. Turn the knob (52) to "0".
11. To turn off the machine, turn the main switch (3) to "0".
12. Disconnect the power supply cable plug (21) from the electrical mains and place it on the holder.
13. Engage the positioning pin (24) and activate the machine transport/parking device (23a) to keep the brush/pad-holder lifted
(see Fig. 3).
14. Make sure that the machine cannot move independently.
NOTE
Each time that the machine is turned off, the solution flow program turns automatically to "ECO" level, to reduce water
consumption.
12
USER MANUAL
Program
Scrubbing and drying.
Brush - vacuum system - solution flow activation
Scrubbing.
Brush - solution flow activation
Drying.
Vacuum system activation
Program
Minimum "ECO" solution flow.
Medium solution flow.
Maximum solution flow.
Closed solution flow.
SC400 - 9099620000