Power The Radio - PERFECTPRO ROCK HART Mode D'emploi

Power the radio

A. Battery Operation
1. Installing the batteries, first turn battery cover fixtures anti-clockwise
to loosen and pull down the battery cover.
Note:
Before you insert the batteries, if you use non-rechargeable batteries,
make sure the NiMH/NiCad/Alkaline switch which located inside the
battery compartment is switched to Alkaline position. If you use
rechargeable batteries, make sure to switch NiMH/NiCad/Alkaline
switch to NiMH/NiCad position.
2. Insert 8 x D size (UM-1) battery into the compartment. Ensure the
battery is inserted in accordance with the diagram shown.
3. Insert x 2 AA size (UM-3) battery into the back up
battery compartment.
Note:
The back up battery is for time and memory station back up during
power failure. It is suggested to replace the back up battery every six
months to avoid battery leakage.
Run time of the radio on batteries varies strongly depending on the
quality and capacity (mAh) of the batteries, temperature,
volume level etc.
4. Close the battery cover and fasten the fixture by turning clockwise.
If the radio is not to be used for any extended period of time,
it is recommended that the batteries are removed from the radio.
Reduced power, distortion and a "stuttering sound" or low battery
sign is flashing on the display are all signs that the batteries need
replacing or recharging (see below Charging the batteries).
GB
8