Charging The Batteries - PERFECTPRO ROCK HART Mode D'emploi

B. AC operation
Before plug the AC power cord into the AC socket, be sure the voltage
is correct. If you have batteries in the radio and connect the AC power
cord into the AC socket, the batteries will automatically be
disconnected.

Charging the batteries

Reduced power, distortion and a "stuttering sound" or low battery sign
" " is flashing on the display are all the signs that the batteries
need to be recharged if you use rechargeable batteries to power
the radio.
Note:
The batteries can be charged only when the radio is off. Connect the AC
power cord into the AC socket to charge the batteries. Be sure the
battery type switch is set to MiMH/NiCad Rechargeable position.
Battery charging function of this radio only applies to the 8 D-size
(UM-1) batteries and not to the AA-size (UM-3) back up batteries.
When the batteries are being charged, the red Charge LED A and B will
be on. LED A and B will turn into green when the batteries of charge
group A or B are fully charged. Charge until both LED A and B are green.
Charging time can take up to approx. 10 hours depending on capacity of
the rechargeable batteries.
Charge new batteries fully the first time before first use. This can take
longer depending on the capacity of the rechargeable batteries
Do not use a mix of old and new rechargeable batteries.
Do not use a mix of full and empty rechargeable batteries.
Do not use batteries that have a different mAh capacity.
Do not use damaged or leaking batteries.
9