Fracarro D-Matrix 4S EVO Instructions D'emploi page 36

Fig.4
Flag the ENABLE box and select the required file in SELECTED FILE. Click on SAVE to save the configuration.
If the file has never been used, the system analyses the format and bitrate to conduct an automatic configuration, creating a file with the same
name but an .FR extension, where the analysis result is stored for future use. The right section lock led should turn on green, showing that the
file is being successfully read. The transport run data are shown in the fields on the bottom right. During the pre-analysis, which can take a few
minutes if the file is very large, the "uploading" status is shown.
When a file is started and the "File OK" status is shown by the green led, the programs in the selected file are added to the list of input programs
and can also be added to the list of output programs.
5.2.3 COMMON INTERFACE CONFIGURATION
The menu COMMON INTERFACE  CAM1 / CAM2 is used to access the CAM module configuration pages, inserted in their respective slots. The
new page will appear as shown in the figure below:
Fig. 5
36