Fracarro D-Matrix 4S EVO Instructions D'emploi page 30

-
FLEX CAM MODE: The FLEX mode allows not to associate the selected CAM to a specific input and creates a customized list of programs to
decrypt by suing the programs coming from any inputs. Set the item "ASSOCIATE TO" as "FLEX" to have the list of all programs coming from the
4 INPUTS in "PROGRAMS". The wanted programs can be decrypted independently from the input the program comes from.
-
OUTPUT MENU: to configure an output signal from D-MATRIX 4S EVO for its distribution.
Wrong PIN
-
DVB-T->DVB-C, DVB-C->DVB-T: the input signal standard can be selected between DVB-T and DVB-C; according to the standard set, other
specific parameters in the output MUX can be viewed and changed or otherwise. For example, if you press the V key on DVB-C -> DVB-T and,
after the request message, you confirm by pressing the V key again, the output standard will switch from the current set DVB-C to DVB-T and
all its parameters will be possibly checked or changed;
-
MUX 1, MUX 2, MUX 3, MUX 4: for selecting which output MUX to configure, after setting the various submenus;
CONFIGURATION: sets all the output MUX parameters;
ENABLE: to enable the selected MUX, if the parameter is set on OFF, the MUX is switched OFF;
CHANNEL OUT:
CHANNEL OUT: to set the output channel where the MUX will be modulated;
this parameter modifies automatically the channel value of the adjacent MUX in the same couple;
COUNTRY: to set the channels for the installation country;
OUTPUT FREQ.:
FREQUENCY (MHz): to set the output frequency where the MUX will be modulated; this parameter
modifies automatically the frequency value of the adjacent MUX in the same couple;
BANDWIDTH: to set the output channel bandwidth from the available ones (7 MHz, 8 MHz, 6MHz);
this parameter modifies automatically the bandwidth value of the adjacent MUX in the same couple.
FEC: to set the FEC (Forward Error Correction) parameter from the available ones (1/2 ,2/3, 3/4, 5/6, 7/8) [only DVB-T];
GUARD INTERVAL: to set the width of the guard interval from the available ones (1/4,1/8,1/16,1/32) [only DVB-T];
CARRIERS NUM.: to set the number of carriers between 2K and 8k [only DVB-T];
CONSTELLATION: to set the constellation used to modulate the carriers as QPSK,16QAM and 64QAM (in DVB-T)
or 16QAM, 32QAM, 64QAM, 128QAM, 256QAM [in DVB-C];
RF LIVEL: to set the output level in dBuV, at steps of 1 dBuV; this parameter modifies automatically the level value of the adjacent MUX
FLOW CHART OUTPUT
after 3 incorrect entries
30
only visible on DVB-T
only visible on DVB-T