Fracarro D-Matrix 4S EVO Instructions D'emploi page 29

-INPUT 1, INPUT 2, INPUT 3, INPUT 4
ASSOCIATE TO: enables deciding whether the SAT signal to use for the input being selected should come from the SAT source directly
connected to the CONNECTOR or from a previous input through a LOOP (for the INPUT 1 the double option is not possible as the signal
must come from a CONNECTOR).
NB: using the LOOP as the SAT signal source just one input can be selected for the subsequent one or for all the subsequent SAT inputs.
For example, if we want to just use INPUT 1 and the LOOP is selected on INPUT 2, INPUT 3 and INPUT 4, all these inputs will receive the
SAT signal from INPUT 1 (with the same polarity set on INPUT 1), and on the remaining inputs only the reception frequency and symbol
rate can be selected.
Remember that if there are any reception anomalies on the main module (SQAT transponder with an instable signal and/or which
unlocks) there could also be reception problems on the modules with the LOOP input; in In this case, the LOOP option must be
deactivated and the SAT signal taken to all the required inputs by activating the CONNECTOR option.
ENABLE: allows deciding whether to use the receiver connected to the selected input, if OFF is selected the receiver is turned off;
TUNER: allows setting the decoder reception parameters after programming the following submenu.
SET BY FREQ;
DISEQC: allows setting the DiSEqC according to the satellite (A, B, C or D);
FREQUENCY (MHz): allows setting the extended frequency for the transponder to be received.
POLARITY: to set horizontal or vertical polarity;
LNB TYPE: to set the type of LNB;
SYMBOL RATE: allows setting the symbol rate for the selected frequency;
SET FREQ. IF
DISEQC: allows setting the DiSEqC according to the satellite (A, B, C or D);
FREQ. IF (MHz): allows setting the IF frequency for the transponder to be received;
LNB: allows setting the parameters for the reception of the selected Transponder
(OFF, 14V/0KHz, 18V/0KHz, 14V/22KHz, 18V/22KHz);
SYMBOL RATE: allows setting the symbol rate for the selected frequency;
MEASURES: contains information relevant to the signal received by the selected input;
LOCK: to check whether the receiver has locked the signal;
NETWORK NAME: shows the transponder name, the parameter can't be changed;
RF LIVEL (dBµV): shows the input signal level;
CBER: to view the BER (quality) of the input signal;
MER (dB): allows viewing the input signal MER.
-
INPUT USB: to manage the USB input as source for an audio/video signal in transport stream after setting its submenu.
ENABLE: allows enabling or otherwise reading the audio/video files in an external USB drive;
SELECT FILE: to select which file to be used in an external USB drive;
USB STATUS: shows the state of the selected file.
NB: D-Matrix 4S EVO only recognises and reproduces audio/video files in TS format and Standard Definition, any other audio/video format
must be converted beforehand using any of the conversion software that can be found in the web.
-
COMMON INTERFACE MENU: consente di impostare i parametri relative alle CAM presenti
FLOW CHART COMMON INTERFACE
Wrong PIN
CAM 1 / CAM 2: to configure the operation of the selected CAM;
MODULE NAME: to verify the common interface module name in the proper slot;
ASSOCIATE TO: to associate the selected CAM to one of the 4 available INPUTS or to set its operation in FLEX mode
(see the specific paragraph);
PROGRAMS: to add or remove the programs to be decrypted;
RESET CAM: to reset the CAM.
after 3 incorrect entries
29
Operating instructions