Fracarro D-Matrix 4S EVO Instructions D'emploi page 33

NETMASK: use a netmask that is compatible with the subnet (default 255.255.255.0)
GATEWAY: gateway address of the subnet (default 192.168.0.1)
DNS: DNS server address, if it is available (default 0.0.0.0)
WEB SERVER PORT: enables changing the web communications port, by default it is set on 80
MAC ADDRESS: to view the address that uniquely identifies the device
ATTENTION: AFTER DEFAULT RESETTING, THESE PARAMETERS ARE REINSTATED TO THOSE SET IN THE FACTORY.
-
LANGUAGE: to set the display language for the unit menus (ITALIAN, GERMAN, FRENCH and ENGLISH are available).
-RESET: to restart the unit
-SAVE CONFIG.: to copy the product configuration on a USB drive in .XML format.
Insert the USB drive in the product USB port before saving the configuration.
-LOAD CONFIG.: allows you to load the product configuration from a file in XML format saved on a pen drive.
-LCD CONTRAST: to regulate the contrast for better display.
-CHANGE PIN: to change the PIN (default 1234) to access programming on the unit.
-FACTORY CONFIG.: to reinstate the D-Matrix 4S EVO to the values set in the factory, deleting all the changes made by the user.
-SW UPDATE: permette di aggiornare il software del sistema utilizzando un pacchetto di upgrade salvato precedentemente in una periferica di
memorizzazione USB.
SOFTWARE REL: to view the SW release installed in the D-MATRIX 4S EVO
RESULT SW UPDATE: to view the outcome of the SW update;
START SW UPDATE: to run the SW update from a USB drive.
After configuring the network parameters using the front panel and connecting to the local network, or to a PC using a cross lead, the web
browser can be used.
EXAMPLE (DIRECT CONFIGURATION FROM A PC):
Change the IP address using one that belongs to the same subnet as the one set in the local net card on the PC.
Parameters set in the PC net card
• IP: 192.168.0.3
• SUBNET MASK: 255.255.255.0
• GATEWAY: 192.168.0.1
Parameters to change in the D-MATRIX 4S EVO network settings:
• IP: 192.168.0.2
• SUBNET MASK: 255.255.255.0
• GATEWAY: 192.168.0.1
Connect the device to the PC using a UTP cross lead CAT-5E or higher.
Start the web browser (recommended: Google Chrome, Mozilla).
In the address bar type in the IP address associated to the D-MATRIX 4S EVO, here 192.168.0.2; the opening screen is displayed shown in figure 1,
requesting the access data. Type the username and password (here the factory settings):
Username: admin.
Password: 1234
Press OK to confirm, the screen is displayed shown in figure 2
5.2 PROGRAMMING BY WEB INTERFACE
FIG. 1
33
Operating instructions