Attaching/Removing The Battery Pack; Storing The Suction Tube And Nozzles; Emptying The Metal Container - Parkside Pwda 20-Li C3 Consignes De Fonctionnement Et De Sécurité

NOTE
If the pleated filter
u
place: Turn the pleated filter slightly without
force, until the inside lock is sitting in place
with the filter basket
lock the pleated filter in place.
Paper filter bag
[ ]
Fig. Q
1. Turn the container lid
2. Align the hole of the paper filter bag
the internal suction connector
3. Press down the paper filter bag
internal suction connector
the paper filter bag.
4. Press down the paper filter bag
seal ring is fitted into the circular rib
[ ]
Foam filter (wet vacuuming)
[ ]
Fig. R
1. Turn the container lid
2. Install the foam filter
3. Gently and slowly pull down the rim of the
foam filter until it covers the filter basket
[ ]
completely. The rim of the foam filter must
reach and touch the bottom surface of the filter
basket.
˜ Operation
˜ Attaching/removing the
battery pack
Fig. S
Attaching the battery pack
1. Lift up the battery compartment cover
2. Attach the battery pack B2 to the battery
compartment until it is click-locked.
3. Close the battery compartment cover
Removing the battery pack
1. Lift up the battery compartment cover
2. Press down the release button for
battery pack B1.
3. Remove the battery pack B2 from the battery
compartment.
4. Close the battery compartment cover
40 GB/IE
does not lock in
[ ]
. Turn the lever
[ ] [
(dry vacuuming)
over.
4 ] [
with
[ ]
.
[ ]
to insert the
[ ]
into the hole of
[ ]
until the
[ ]
[
over.
[ 4 ]
to the filter basket
[ ] [
.
[ 5 ]
.
[ 5 ]
.
5 ] [
.
[ 5 ]
˜ Switching on/off
NOTE
Before use, check if all parts are connected
u
securely and the container lid
to
]
in place.
Before you connect the battery pack B2
u
to the product: Make sure the product is
switched off.
Fig. A
Switching on: Press the on/off switch
o
position I.
Switching off: Press the on/off switch
o
position 0.
˜ Storing the suction tube and
nozzles
.
]
Fig. T
Slide the suction tube
o
swivel caster
All nozzles
o
.
]
this way.
˜ Emptying the metal container
[ ]
m WARNING!
Remove the battery pack B2 before
replacing attachments, cleaning and
when not in use.
m WARNING!
Empty and clean the product before and
u
after use to avoid the collection of materials
that could pose a fire hazard in the product.
Fig. U
1. Remove the container lid
container
7 ] [
2. Empty the metal container
[ 4 ]
into the holder of the
[ ]
.
8 ] [
/ / / can be stored in
[ ] [ ] [ ] [ ]
from the metal
4 ] [
.
.
7 ] [
is locked
to
2 ] [
to
2 ] [