Assembling The Swivel Castors; Connecting/Removing The Flexible Hose; Connecting/Removing The Handle; Connecting The Nozzles/Extension Tube - Parkside Pwda 20-Li C3 Consignes De Fonctionnement Et De Sécurité
Table des Matières
Les langues disponibles
Les langues disponibles
Charging control LEDs Status
Green LED C3 lights up
Green LED C3 and red
LED C4 flashing
Red LED C4 flashing
Green LED C3 lights up
(without battery pack B2 )
˜ Assembling the swivel castors
Fig. E
1. Turn the metal container
its bottom is facing upward.
2. Insert the swivel castor
plastic holder until it is click-locked.
3. Check if the swivel castor
˜ Connecting/removing the
flexible hose
Vacuuming
Fig. F
1. Align the hose coupler
hose
with the vacuum connector
[
]
2. Push the hose coupler
vacuum connector
[
6 ]
clicks into place.
3. Check if the flexible hose
properly by pulling the hose coupler
slightly. If the hose coupler does not move, the
flexible hose is connected properly.
4. Check if the flexible hose
freely.
5. Removing: Press the lock button
Pull the hose coupler
connector
.
6 ]
[
38 GB/IE
Battery pack B2
fully charged
Battery pack B2
defective
Battery pack B2
too cold or too
warm
Battery charger C2
ready
upside down, so
7 ]
[
into the slots of the
[
8 ]
can rotate freely.
[
8 ]
of the flexible
[
]
.
6 ]
[
slowly into the
[
]
until the lock button
[
is connected
[
]
[
]
can be rotated
[
]
down.
[
]
out of the vacuum
[
]
Blowing air
Fig. G
NOTE
Blowing air is an auxiliary function which
u
can be used to blow away dust or small
objects.
1. Align the hose coupler
hose
with the blow connector
[
]
2. Push the hose coupler
connector
[
]
into place.
3. Check if the flexible hose
properly by pulling the hose coupler
slightly. If the hose coupler does not move, the
flexible hose is connected properly.
4. Check if the flexible hose
freely.
5. Removing: Press the lock button
Pull the hose coupler
connector
.
[
]
˜ Connecting/Removing the
handle
Fig. H
Connecting the handle: Align the hose
o
coupler
of the flexible hose
[
]
handle
. Push the hose coupler until the hose
[
]
]
coupler is securely connected to the handle.
Removing the handle: Pull out the hose
o
coupler
from the handle
[
]
˜ Connecting the nozzles/
extension tube
Fig. B, J, K, L
You can connect the nozzles
o
and the suction tube
[
]
in various ways in order to adapt to different
environments and degrees of accessibility.
Nozzle
Floor nozzle for hard
floor
[
]
Floor nozzle for
carpet
[
]
of the flexible
[
]
.
[
]
slowly into the blow
[
]
until the lock button
[
]
is installed
[
]
[
can be rotated
[
]
down.
[
]
out of the blow
[
]
to the
[
]
.
[
]
/
/
[
]
[
]
to the handle
[
]
Area of application
Hard and flat
o
surfaces
Carpets or similar
o
types of surface
clicks
]
/
[
]
[
]
Chapitres
Table des Matières
