Using The Handle; Removing The Container Lid - Parkside Pwda 20-Li C3 Consignes De Fonctionnement Et De Sécurité

Nozzle
Housekeeping
nozzle
[ ]
Crevice nozzle
[ ]
˜ Using the handle
Fig. I
Handle
NOTE
The handle has a built-in air pressure
u [ ]
regulation function.
Decrease suction power: Slide the air
o
regulator in the opposite direction of the
[ ]
mark.
Increase suction power: Slide the air
o
regulator in the same direction of the
[ ]
mark.
˜ Removing the container lid
NOTE
Remove the container lid
u
or replacing the filter bag and emptying the
metal container
7 ] [
Fig. M
1. Unlock the latches
[ 9 ]
from the metal container
2. Lift up the latches
9 ] [
the rib .
[ ]
3. Reverse above steps to lock the container
lid on the metal container
[ 4 ]
Fig. N, O
1. Hold the carry handle
container lid from the metal container
[ 4 ]
2. The filter basket
[
installation or replacement.
Area of application
Car seats
o
Cushions
o
Sofas
o
Matresses
o
Grooves
o
Joints
o
Sofas
o
Car seats
o
Confined spaces
o
for installing
[ 4 ]
.
by pulling them away
.
7 ] [
and disconnect them from
.
7 ] [
and remove the
[ 1 ]
7 ] [
is exposed for filter
]
3. Fold down the carry handle
before storing the product.
˜ Installing the filter
CAUTION!
m
Never vacuum without a filter installed to the
u
product. Sucked in substances may contain
metal or hard, sharp particles, which may
damage the motor or cause an electric
shock. Dust would be blown out from the
blow connector
which could cause serious personal injury.
Only vacuum liquids with the foam filter
u
installed to the product. Otherwise the
product will be damaged. The paper filter
bag will also be damaged, if you use it
[ ]
for wet vacuuming.
NOTE
The pleated filter
u
bag are suitable for dry vacuuming only.
[ ]
Do not use the pleated filter
u
vacuuming very fine dust or dirt (e.g.
sanding dust). The pleated filter can be used
for many other materials though.
Pleated filter
[
Fig. P
NOTE
Before installing pleated filter, ensure the
u
lever is unlocked.
[ ]
1. Turn the container lid
2. Install the pleated filter
basket .
[ ]
3. Insert the pleated filter
of the pleated filter touches the surface of the
filter basket
[
4. Turn the lever
in place.
5. Pull the pleated filter
movement, to check if the pleated filter is
installed properly.
.
after use and
1 ] [
at a very high speed
[ ]
and the paper filter
[ ]
for
[ ]
(dry vacuuming)
]
over.
[ 4 ]
to the filter
[ ]
until the bottom side
[ ]
.
]
to lock the pleated filter
[ ]
slightly without
[ ]
GB/IE
[ ]
[ ]
39