GE PSB48YPHASV Manuel Du Propriétaire Et Instructions D’installation page 5

About the temperature controls.
GEAppliances.com
The temperature controls are preset in the factory at 37°F for
the refrigerator compartment and O°F for the freezer compartment,
Aflow 24 hours for the temperature to stabilize, to the preset
recommended settings,
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer,
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
NOTE: The refrigerator is shipped with protective film covering
the temperature controls, If this film was not removed during
installation, remove it now,
To change the temperature, press and release
the WARMERor COLDERbutton, SETwill illuminate in the
display, as well as the set temperature, To change the
temperature, tap either the WARMERor COLDER button
(while SETis illuminated) until the desired temperature
is displayed, Refrigerator temperatures can be adjusted
between 34°F and 47°F and
the freezer temperatures can be adjusted
between -6°F and +8°F,
Once the desired temperature has been set,
the temperature display will clear after 10 seconds,
To display the temperature, the DISPLAYTEMPbutton
may be tapped,
Several adjustments may be required, Each time you
adjust controls, allow 24 hours for the refrigerator to
reach the temperature you have set,
Performance Air Flow System
The Performance Air-Flow System is designed to
maximize temperature control in the refrigerator
and freezer compartments, This unique special feature
consists of the Air Tower along the back
wall of the refrigerator and the freezer, Placing food
in front of the louvers on these components will not
affect performance,