GE PSB48YPHASV Manuel Du Propriétaire Et Instructions D’installation page 10

About the ice and water dispenser and automatic icemaker.
A newly insta//ed refrigerator may take 12 to 24 hours to begin making ice.
Ice Storage Bin
AccessDoc/_
ce S_orage ./-
Bin _ __
Drive
Mechanism
To remove:
Lift up the access door to reach the
icemaker. Set the icemaker power switch
to the O (oft) position. With the access door
closed, support the storage bin at
the bottom while slightly lifting. Pull bin
straight out.
To replace:
Slide the bin back until the tab on
the bin locks into the slot on the shelf.
If the bin does not go all the way back,
remove it and rotate the drive mechanism 1/4
turn. Then push the bin back again.
Important facts about your
ice and water
dispenser
Do not add ice from trays or bags to the
storage bin. It may not crush or dispense well.
, Avoid overfilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in the
chute to freeze shut. If ice is blocking the
chute, poke it through with a wooden spoon.
iiiiiiiiiiii_i_
iiiiiii#_i_
iiiiiii#_i_
Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the storage
bin may cause the icemaker
or auger to jam.
To keep dispensed ice from missing
the glass, put the glass close to, but not
touching, the dispenser opening.
Some crushed ice may be dispensed
even though you selected CUBED. This
happens occasionally when a few cubes
accidentally get directed to the crusher.
After crushed ice is dispensed, some water
may drip from the chute.
The first glass of water dispensed may
be warmer than the following ones.
This is normal.
Power
ce maker
Gre(
Light
Automatic Icemaker
Avoid contact with the
moving parts of the ejector mechanism, or with
the heating element (located on the bottom of
the ice maker) that releases the cubes. Do not
place fingers or hands on the automatic ice
making mechanism while the refrigerator is
plugged in.
A newly-installed refrigerator may take 12-24
hours to begin making ice.
The icemaker will produce seven cubes per
cycle-approximately 15 cycles or more in
a 24-hour period, depending on freezer
compartment temperature, room temperature,
number of door openings
and other use conditions.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
power switch to O(off)
When the refrigerator has been connected to
the water supply, set the power switch to/(on)
The green light will come on.
Throw away the first full bucket of ice.
Be sure nothing interferes with the sweep of the
feeler arm.
When the bin fills to the level of the feeler arm,
the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink.
After the icemaker has been turned on again,
there will be a delay of about 45 minutes before
the icemaker resumes operations.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker water
valve cycle on several times when making one
batch of ice Recommended water pressure is
60 psZ
10