GE PSB48YPHASV Manuel Du Propriétaire Et Instructions D’installation page 30

Installation Instructions
3/4" FULL-WIDTH OVERLAY CUSTOM PANELS WITH CUSTOM HANDLES
This panel design provides a nearly trimless appearance.
Assemble the spacer panel onto the backer panel. Allow 1/2" clearance on all four sides of the grille spacer
panel. Allow 1/2" clearance on the top, hinge side and handle side, and 15/1 6" on the bottom of the upper
freezer door panel. Allow 15/1 6" on the top and 1/2" clearance on the bottom, hinge side and handle side
of the lower freezer door panel. Secure the panels with glue. Be sure to observe clearances on all sides.
Secure the appearance panel to the assembled backer/spacer panel. Use glue
and screws. Countersink screws into the backer panel.
Grille Panel
I/4" Backer Panel 39-15/16" 10-3/4"
0.10" Spacer Panel 38-15/16" 9-3/4"
3/4" Overlay Panel 40-3/16" 11"
1/4" Backer Panel 45-15/16" 10-3/4"
0.10" Spacer Panel 44-15/16" 9-3/4"
3/4" Overlay Panel 46-3/16" 11"
Upper Freezer Panel
I/4" Backer Panel 16-7/16" 17-13/16"
0.I0" Spacer Panel 15-7/16" 16-3/8"
3/4" Overlay Panel 16-7/16" 17-5/8"
1/4" Backer Panel 18-7/16" 17-13/16"
0.10" Spacer Panel 17-7/16" 16-3/8"
3/4" Overlay Panel 18-7/16" 17-5/8"
Lower Freezer Panel
1/4" Backer Panel 16-7/16" 35-1/8"
0.10" Spacer Panel 15-7/16" 33-11/16"
3/4" Overlay Panel 16-7/16" 34-15/16"
1/4" Backer Panel 18-7/16" 35-1/8"
0.10" Spacer Panel 17-7/16" 33-11/16"
3/4" Overlay Panel 18-7/16" 34-15/16"
5/16"
5/16"
Upper Freezer Panel
Spacer Assembly
112"
1/2"
c_
z
=<
Lower Freezer Panel
Spacer Assembly
1/2"
1/2"
F_nished Finished
Ba ;kerr Racker
Panel Panel
30