GE PSB48YPHASV Manuel Du Propriétaire Et Instructions D’installation page 35

Installation Instructions
FS]CONNECT POWER
• Connect refrigerator power cord plug to
a properly grounded receptacle, Set the
Master Power switch to the I (ON) position.
o
Raise _ _cl
x__i!!i_i!::i!jji Grille j ;; "_i
_Z_Panel IS J.{i
_" X
Master Water Filter
Power Switch
5,£
• Check to make sure power to refrigerator
is on by opening refrigerator door to see
if interior lights are on.
• After power has been established, turn the
Master Power switch to the 0 (OFF) position.
r6-]MOVE INTO INSTALLATION SPACE
• Slide the unit into the installation space,
• Place excess slack in the power cord on top
of the refrigerator,
• Use care to ensure the power cord is not
pinched behind the unit.
Height
from
FI00rt0
Bottom
of Wood
Block
82"
[] LEVEL REFRIGERATOR
All models have 4-point leveling. The front and back
are supported by leveling legs. Both are accessible
from the front of the refrigerator.
• To level the back of the refrigerator, turn the 1/2"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower
the refrigerator.
• For front leveling, use a 7/16" open-end wrench.
• Adjust height of refrigerator to match
installation cutout opening 83-1/2" to 84-1/2".
The refrigerator should be level and plumb with
cabinets.
Leveling L eg
/
HexNutAdjusts
RearLevelingLegs
IMPORTANT NOTE: The refrigerator must be level.
If it is not, the doors may not align evenly at
the top. See Step 16.
NOTE: The rear leveling legs and front leveling legs
are limited to a maximum height adjustment
of 1 ". If the installation requires more than 84-1/2"
height, the installer should elevate the refrigerator
on a sheet of plywood or runners. Cabinet trim
could be added across the top of the opening
to shorten the opening. If you attempt to raise
the refrigerator more than 1 ", you will damage
the front and rear leveling legs.
35