GE PSB48YPHASV Manuel Du Propriétaire Et Instructions D’installation page 34

Installation Instructions
_WATER LINE INSTALLATION WITH
A REVERSE OSMOSIS SYSTEM
SKIP THIS STEP WHEN NOT USING AN RO SYSTEM
NOTE: If the water supply to the refrigerator
is from a Reverse Osmosis Water System, use
the refrigerator's filter bypass plug. Using the
refrigerator's water filtration cartridge with
the RO filter can result in hollow ice cubes.
Master Power Switch Water Filter
Rotate Counterclockwise To Remove
• Open the top grille to view the filtration cartridge.
Rotate the filtration cartridge counterclockwise
until removed.
• Insert filter bypass plug. Rotate the filter bypass
plug clockwise until tightly secured in place.
r3] INSTALL SIDE PANELS
SKIPTHIS STEPWHEN NOT USING SIDE PANELS
If you are using 1/4" side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with the 3M Dual Lock adhesive strips
before setting refrigerator in place.
[_] INSTALL ANTI-TIP BRACKETS
ANTI-TIP PRECAUTIONS
The refrigerator is Top-Heavy and must be secured
to prevent the possibility of tipping forward•
• Cut a 2"x 4"wood block 36" long,
and secure the block .......... I ', ! ,,
to the mounting _ _<-_- ;-._
brackets _' BI_-_ j
provided, using
#12 or #14 _f ]_ I i Positioned
/ _ j , ! A . T
wood screws ..... _ !
_,
. AntkHp
• vv00a bcrews i ! i , Brac<et
• Secure the brackets Mounted into i i_ i
• Vertical i i ,
with wood block WoodStuds!s _ _Wall Stud
to the back wall so " #'_ I (Behind
that it is 82" (or the rear Drywall)
installation height) from the finished floor• Use
#12 or #14 wood screws•
34
[] INSTALLANTI-TIP BRACKETS
(cant,)
Screws
Brackets
must
Required
penetrate
at least 1"
into vertical
wall studs•
Height
From
Floor
to
Bottom
of Wooc
Block
Side View
ALTERNATE ANTI-TIP
PRECAUTIONS
The refrigerator must be secured to prevent tipping.
The anti-tip brackets cannot be used on metal wall
studs. Use this Alternate Procedure to secure the
refrigerator against tip-over whenever metal wall
studs are encountered and there is not soffit.
(3/a ")
min.
i \ Side View
Top Case Trim
\
\
" H-o
.1,.. ','
or 3/4" Min, Wood Brace
• Adjust height of refrigerator to match
installation cutout opening 83-1/2" to 84-1/2".
The refrigerator must be level and plumb with
cabinets. The top case trim at the front is 2-1/8"
higher than the rear and will overlap upper
cabinets or cabinet trim.
• Open grille panel to access the top case trim.
• Use a 3/16"bit to drill 4 evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill pilot holes through the
metal clearance holes and into wood soffit. The
holes should be centered in the soffit or a 3/4"
minimum wood brace. The brace spanning the
enclosure must be securely fastened to cabinets
on both sides.
• Install four 1-1/2" drywall screws into the pilot
holes.