Cutting Procedures - Hitachi C 7SB2 Instructions De Sécurité Et Mode D'emploi

English

CUTTING PROCEDURES

WARNING:
Never touch the moving parts.
●
Should the saw blade be stopped or make an abnormal noise during operation, turn off the switch
●
immediately.
Don't remove circular saw from work piece during a cut while the saw blade is moving.
●
Always wear eye protection with side shields that meets the requirements of ANSI Standard Z87.1.
●
Ordinary eyeglasses do not provide adequate protection.
Avoid cutting any material like metal, etc., that give off sparks.
●
Do not use any abrasive wheels.
●
Use only blade diameter specifi ed on the product nameplate.
●
CAUTION:
Always take care in preventing the power cord from coming near the revolving saw blade.
●
Before starting to saw, ensure that the saw blade has reached full speed revolution.
●
1. Place the saw body (base) on the work piece, and as in Fig.
12 align the intended line of cut with the saw blade, using
the notch at the front of the base. This relationship of base
to work pieces should remain unchanged regardless of the
inclination of the base.
2. The switch should be turned to the ON position before the
saw blade comes into contact with the work piece. The switch
is turned ON when the trigger is pulled by one's fi nger, and is
turned OFF when the trigger is released.
3. Moving the saw straight at a constant speed will produce
optimum cutting.
[POCKET CUTTING]
WARNING:
To avoid serious accident, ensure the switch is OFF
●
position, and disconnect the plug from the receptacle
before any adjustment.
Never tie or wedge the lower guard in a raised position.
●
1. Mark the desired cutting area clearly with lines all side. (See
Fig. 13)
2. Set depth adjustment according to material to be cut.
3. Push the lever all the way back so the blade is exposed as
shown in Fig. 13.
12
When
When not
Inclined 45°
Inclined
Fig. 12
Fig. 13
Lever