Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAT2
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-15.
Fig. 6 on page EN-11
1 Remove the parts to be disconnected.
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the CAT2 to be properly disposed of, it first must be
dismounted.
See 11 Dismounting on page EN-16
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Oils, greases and cleaning agents must not contaminate the ground and not
enter sewage systems. These materials must be stored, transported and
disposed of in suitable containers. Please observe the relevant local regulations
and disposal instructions of the safety data sheets given by the manufacturer of
the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the
manufacturer of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
12 Disposal
EN - 17
Publicité
Table des Matières
