Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7 Operation
6.3 Connect the helix cable
6.4 Activating the LED function
7 Operation
EN - 14
1
Washer
2
Torch mount
Fig. 8
Adjusting TCP
3 Drill the mount (4) with Ø 5.8mm and ream the bore for the dowel
screw (3) using a reamer.
4 Fix both mounts (4) (2) using dowel screw (3).
Fig. 6 on page EN-11
1 Plug the helix cable (4) with a right angle plug on the connector
housing (5).
2 Plug the flange plug on the torch and cable assembly.
3 Lock both plugs against unintentional loosening.
For the switching function please see the functional diagram.
Fig. 5 on page EN-10
The green LED shows a trouble-free operation of the CAT2 robot mount. In case
of collision the switching voltage is switched off and the LED goes out.
Fig. 5 on page EN-10
1 Assign GND on PIN 1 on the plug.
Due to the fact that the CAT2 is integrated into the welding process of the torch,
the operating steps are performed after the respective torch has been put into
operation.
1
2
5
3
Dowel screw 6H7
4
Mount
CAT2
3
4
5
Nut
Publicité
Table des Matières
