Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5 Functional Description
5 Functional Description
2
NC
1
3-pin flange plug
Fig. 5
Functional diagram
6 Putting into operation
EN - 10
The inserted springs "S", "M", "L" or "XL" act with their holding force directly
upon the triggering flange and fix the switching axis in the zero position by
balls. In case of collision the switching axis tips over and the triggering flange
pushes the spring plate in direction of the bottom of the case and the switch
cam detaches itself from the actuating element of the micro switch. The applied
switching voltage is interrupted.
R 1,2k
D1
3 2 1
3
2
4
1
NO
C
2
Micro switch in resting position
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
• Pull the mains plug.
NOTE
• The CAT2 mount may only be put into operation by trained personnel.
1
1
1
GND
2
2
24 V DC
3
3
Signal
3
2
3
Micro switch triggered
CAT2
Publicité
Table des Matières
