Hitachi C 10FSHC Mode D'emploi page 15

3. Releasing the locking pin
Switch
Handle
Fig. 6
4. Installing the dust bag and vise
Dust bag
Fig. 7
CAUTION:
WARNING:
(Attach the vise assembly as shown in Fig. 1, Fig. 2 and Fig. 25.)
Locking pin
Pull
Dust port
Empty the dust bag frequently to prevent the duct and the lower
guard from becoming clogged.
Sawdust will accumulate more quickly than normal during bevel
cutting.
Do not use this saw to cut and/or sand metals. the hot chips or
sparks may ignite saw dust from the bag material.
When the power tool is prepared for shipping, its
main parts are secured by a locking pin.
Press the handle slightly down and pull out the
locking pin to disengag the cutting head.
NOTE:
Lowering the handle slightly will enable
you to disengage the locking pin more
easily and safely. The lock position
of the locking pin is for carrying and
storage only.
Install the dust bag onto the dust port on the miter
saw. Fit the connecting tube of dust bag and the dust
port together.
To empty the dust bag, pull out the dust bag assembly
from dust port. Open zipper on underside of bag and
empty into waste container. Check frequently and
empty the dust bag before it gets full.
NOTE
: The dust bag should be angled toward
the right side of the saw for best results.
This will also avoid any interference
during the saw operation.
English
15