Thermopatch Y151 Thermo-Seal Manuel Utilisateur page 58

Front side of
Bottom Chassis
M5 Screw Slots
(2x)
20150901 47314-INSTR
V. 4.0 F
page 4 of 5
Oct.2015
Manual Y151 V. 4.0 FR EUR from original TPC 47117-MAN Rev 1214
INSTALLATION OF THE NEW PRESS ARM SWITCH (47314)
• CAREFULLY INSTALL THE NEW PRESS ARM SWITCH INTO
THE BOTTOM OF THE CHASSIS AS SHOWN IN FIGURE-4.
FIGURE-4. INSTALLATION OF THE PRESS ARM SWITCH
• MOVE THE PRESS ARM SWITCH BRACKET SO THAT THE
MOUNTING HARDWARE IS TOUCHING THE REAR SIDE
OF THE MOUNTING HOLES AS SHOWN IN FIGURE-5.
TIGHTEN THE HARDWARE USING A 5 MM HEX KEY
WRENCH.
FIGURE-5. PRESS ARM SWITCH ASSEMBLY M5
MOUNTING SCREWS
58 58
ASSEMBLY