Thermopatch Y151 Thermo-Seal Manuel Utilisateur page 48

Masquer les pouces Voir aussi pour Y151 Thermo-Seal:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V. 4.0 F
Oct.2015
Manual Y151 V. 4.0 FR EUR from original TPC 47117-MAN Rev 1214
7. Remove the black tubing from the Dynamic Knife Actuator
Cylinder
Locate the black tubing at the bottom of the Dynamic
Knife Actuation Cylinder (47204)
Remove the black tubing from the bottom of the Dynamic
Knife Actuation Cylinder by pushing up against the black
knob and pulling down on the black tubing
8. Remove the Dynamic Knife Actuator Spring Assembly
(SPA47929) from the Y151T-110/220 Machine
Push up against the Press Arm Assembly and keep it in
place
Place a 8mm Wrench around the M5 Hex Lock Nut
Remove the M5 Hex Lock Nut and M5 Hex Nut
Release the Press Arm Assembly into its original position.
Locate (2) Button Head Hex Socket Screw
Insert a 2.5 mm Allen Hex Key Wrench into the Button
Head Hex Socket Cap Screw
Remove all Button Head Hex Socket Cap Screw
Carefully pull out and remove the Dynamic Knife Actuator
Spring Assembly from the Y151T-110/220 Machine
Keep all hardware and parts
48
48

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour Thermopatch Y151 Thermo-Seal

Table des Matières