Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V. 4.0 F
Oct.2015
Manual Y151 V. 4.0 FR EUR from original TPC 47117-MAN Rev 1214
9. Remove the Dynamic Knife Pivot Block
•
Locate the M5 Hex Nut Elastic Lock (21051-31-G) on the
Dynamic Knife Assembly
•
Insert a 8mm Wrench around the M5 Hex Nut Elastic Lock
•
Remove the M5 Hex Nut Elastic Lock and the Flat Washer
•
Locate the (2) Socket Hex Cup Point Set Screw (21049-
06-C) on top of the Stanchion, Right
•
Insert a 1.5 mm Allen Hex Key Wrench into the (2) Socket
Hex Cup Point Set Screw
•
Loosen the (2) Socket Hex Cup Point Set Screw until the
Knife Pivot Shaft (47110) can be freely pulled out
•
Remove the Knife Pivot Shaft and the Dynamic Knife Block
Assembly from the Y151T-110/220 Machine
•
Locate the (2) Button Head Hex Socket Screw (21061-
17-R) and Lock Washer (21046-03-A) that is holding the
Cutter Actuator to the Dynamic Knife Block Assembly.
•
Insert a 2.5 mm Allen Hex Key Wrench into the (2) Button
Head Hex Socket Screw
•
Remove both Button Head Hex Socket Screw
•
Remove the Cutter Actuator and the Blade Dynamic Knife
from the Dynamic Knife Block Assembly
49
49
Publicité
Chapitres
Table des Matières
