Stihl RMA 239.1 Notice D'emploi page 32

English
fingers between the moving blade and fixed
parts of the lawn mower.
► Work carefully.
► Wear protective gloves.
5 Preparing the Lawn Mower
for Operation
5.1 Preparing the lawn mower for
operation
The following steps must be performed before
commencing work:
► Remove the packaging material and transport
locks.
► Ensure that the following components are in a
safe condition:
– Lawn mower,
– Blade, 4.6.2.
– Battery, 4.6.3.
► Check the battery,
► Fully charge the battery,
► Clean the lawn mower,
► Check the blades,
► Attach the handlebar,
► Fold open the handlebar,
► If mowing and the mown grass is to be collec‐
ted in the grass catcher box: Attach the grass
catcher box, 7.3.2.
► If mowing and the mown grass is to be ejected
to the rear: Detach the grass catcher box,
7.3.3.
► Select the cutting height,
► Check the controls,
► If you cannot carry out these steps: Do not use
the lawn mower and instead consult a STIHL
authorized dealer.
6 Charging the Battery, LEDs
6.1 Charging the Battery
The charging time depends on various influenc‐
ing factors such as the temperature of the battery
and the ambient temperature. For optimum per‐
formance, note the recommended temperature
ranges, 19.5. The actual charging time may
differ from the specified charging time. For infor‐
mation on charging times, see www.stihl.com/
charging-times.
► Charge the battery as described in the instruc‐
tion manual for the STIHL AL 101, 301, 501
charger.
32
4.6.1.
10.3.
6.1.
15.2.
10.2.
7.1
7.2.1.
11.2.
10.1.
5 Preparing the Lawn Mower for Operation
6.2 Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
18.1.
There is a malfunction in the mower or battery.
7 Assembling the Lawn
Mower
7.1 Attaching the Handlebar
► Switch the lawn mower off and remove the
battery.
► Place the lawn mower on a level surface.
► Push bolt (1) through the bore in cable
guide (2).
► Fit upper handlebar (3) onto lower handle‐
bars (4).
► Attach cable guide (2) to cable (5).
► Push the bolt with cable guide (2) through
bore (6) from the inside to the outside.
► Push bolt (7) through bore (8) from the inside
to the outside.
80-100%
60-80%
40-60%
20-40%
0-20%
0478-131-9929-A