Create Wind Stylance Manuel D'instructions page 13

MOU N T I NG THE F I NIA L
1
1. Lift the finial up to the mounting bracket and align the loosened screws in the mounting
bracket with the holes in the finial.
2. Turn the finial to adjust and reinsert the screws.
3. Secure the screws with the help of a screwdriver.
4. Then lift the decorative cover towards the rosette so that it is fixed with the built-in magnet.
Advice: Another person should help you hold the ladder and hand you the fan once you are
on the ladder.
M OUN TI N G TH E B L ADE S
Align the holes in the blade holder with the holes in the blades and motor body and screw
them into place, but do not tighten the screws until they are all in place and screwed in.
Advice: To save time, you can place the washers on each screw before installing the blades.
M OUN TI N G TH E PATCH PANE L
* Only for the model WITH LIGHT
• Attach the connection panel to the bottom of the fan by inserting the screw heads into the
holes provided.
• Screw in the screws and then secure them.
Note: While installing or removing the patch panel, carefully keep the insulation pads in-
tact. Turning the fixing screws too hard or too fast will damage the insulating pads.
2 3
Patch panel
4
Panel screws
E NGLI SH
5
13