Create Wind Stylance Manuel D'instructions page 10

• Mark the correct position of the holes and secure the ceiling bracket using the screws with
metal anchors or screws and washers appropriate to the type of ceiling chosen.
• Check that the bracket is installed correctly before hanging the fan. This plate must sup-
port the entire weight of the fan.
PRE PARI N G FOR I NSTALL AT I O N
min. 50 cm
• To avoid personal injury or damage, ensure that the location where you plan to hang the
fan allows the blades to be at least 2.3 m from the floor and 50 cm from the nearest wall
or obstacle.
• Make sure the junction box is adequately attached to the building structure and can sup-
port the full weight of the fan.
INSTALLI N G THE MOUNT ING B R ACKE T
• Check that the ceiling where you intend to mount the fan is stable and capable of safely
supporting the weight of the fan.
• Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
• Mark the correct position of the holes and fix the ceiling bracket using screws with metal
anchors or screws and washers suitable for the chosen ceiling type.
Wood roof
Drill the necessary holes
and then secure the mount-
ing bracket with the wood
screws and washers to the
ceiling joints.
* The waterproof cover is only required for outdoor use.
• Once the fixing bracket is installed, check its correct installation before hanging the fan.
The mounting bracket must support the full weight of the fan.
E NGL I SH
10
INSTALLATION INSTRUCTIONS
min. 2.3 m
Concrete roof
Drill holes with an 8mm drill
bit, according to the length
of the expansion screws.
Next, secure the mounting
bracket to the ceiling with
the expansion screws.
min. 50 cm
Drill the necessary holes and
then fix the mounting brac-
ket with the special spring
lever fixing screws for use in
false ceilings.
min. 2.3 m
False ceiling