shark RIDILL-2 Manuel D'utilisation page 29

COMMUNICATION SYSTEMS
(Available as
replacement part)
Your helmet is designed to be
equipped with the SENA FOR SHARK
(Bluetooth or Mesh) communication
system.
If your helmet is approved according
to UNECE Regulation No. 22-06, it
has also been tested and approved
with SENA FOR SHARK (Bluetooth or
Mesh) installed. The installation of a
system other than SENA FOR SHARK
(Bluetooth or Mesh) compromises
the regulatory compliance of the
helmet. During the installation of the
communication system, see specific
instructions in the SENA FOR SHARK
(Bluetooth ou Mesh) kit.
INSTALLATION OF THE SENA FOR
SHARK SYSTEM
Your helmet is approved for SENA FOR
SHARK (Bluetooth or Mesh).
Follow these steps to install your
communication system.
1. To do this, remove the textile
liner according to the disassembly
description on page 22 - 24.
2. Remove the white Styrofoam PAD in
the space provided at the back of the
helmet Fig. 31
an accessory
Fig. 31
/
3. Affix the foam cushioning present
in your Sena FOR SHARK kit (Bluetooth
or Mesh) to the back of the battery of
your Intercom Fig. 32.
4. Insert the battery (with foam) into
the space provided at the back of
the helmet, in accordance with Fig. 33
a/b/c, the foam cushioning must be
between the battery and the shell.
5. Remove the textile cheek pads
according to
description (page 22 - 24).
Fig. 32
Fig. 33a
Fig. 33b
Fig. 33c
the disassembly
29
29