shark RIDILL-2 Manuel D'utilisation page 23

3 - Un-clip the front part of the comfort
liner, clip by clip, by pulling inwards
starting from either of the two ends.
4 - The comfort liner is completely
detached and can now be removed.
ASSEMBLING THE INTERIOR
3
1 - Slide the comfort liner into the
helmet. Check that it has been
reinserted the right way around.
Reposition the front of the comfort
liner. Clip the five clips into their slots.
Start with the middle clip which must
be slid over the arrow shown on the
comfort liner support, then one by one
the next four side clips.
4
2 - Put back the rear of the inner
lining.
1
2
23
23