shark RIDILL-2 Manuel D'utilisation page 13

MAINTAINING THE VISOR
Clean the visor using mild liquid soap,
lukewarm water and a soft damp rag
only. Allow the visor to dry naturally
before reassembling it.
WARNING! Do not use abrasive
cleaning agents, liquids contai-
ning ammonia or alcohol.
For your own safety, never ride with
a visor that does not provide perfect
visibility. If your visor no longer
provides excellent visibility after a
period of use, it must be replaced
without fail.
INSTALLING THE PINLOCK®
Your RIDILL 2 is pre-designed to fit
a PINLOCK®; a flexible plastic lens
that absorbs moisture. When fitted
against your visor, it offers very effec-
tive anti-fog protection. It prevents
the formation of micro-droplets that
compromise your field of view.
MIN
1 – Place the visor on a work surface
and on a soft covering. Make sure that
the inner surface of the visor is clean.
Use a coin to check that the external
adjustment levers are positioned
inwards (positioned to «MIN»).
MAX
1
2 – Place the PINLOCK® lens on
the visor. The silicone seal of the
PINLOCK® lens must be in contact
with the inner surface of the visor.
The PINLOCK® logo is visible on the
outside of the visor.
3 - Insert one side of the PINLOCK®
lens into one of the two pins at
the ends of the visor and hold it in
position.
4 – Extend and flex the visor and fit
the second side of the PINLOCK® lens
into the second pin. Release the visor
so that it reacquires its curved shape.
2
3
4
13
13