shark RIDILL-2 Manuel D'utilisation page 24

ASSEMBLING THE INTERIOR
5 - Reposition each of the two comfort
liner clips to face their slot on one
side and then the other and press
them into place.
6 - Check that the comfort liner is
properly repositioned and is stretched
from the front to the back of the
helmet.
WARNING! The positioning of
the interior is critical to how
the helmet fits your head. If you have
any doubts about how the interior
was removed or reinstalled, do not
use your helmet. Contact your retailer
for assistance and advice. Never use a
helmet without any one of its interior
parts, as it will not protect you in the
event of an accident.
24
24
WARNING! The cap and the inte-
rior comfort liner are made to
fit perfectly on your head. In the event
of an accident, a helmet that does not
fit you may come off, leaving your
head unprotected and causing serious
or even life-threatening injuries.
POSITIONING THE CHEEK PADS
3
1 - Thread the corresponding chinstrap
end through each of the cheek pads.
Use the red snap fasteners to guide
you in identifying in which direction
the cheek pads must be reinserted.
4
2 - Clip each of the three clips per
cheek pad into their slots, starting
with the rear clip, then the middle clip
and finally the front clip.
3 3
2 2
1 1
1
2