shark RIDILL-2 Manuel D'utilisation page 22

REMOVING THE CHEEK PADS
3 - Turn the helmet over again to more
easily undo two front snap fasteners,
one side velcro fastener and one rear
snap fastener on each cheek pad.
Hold the two velcro surfaces on either
side in place as much as possible in
order to gently loosen the area (A).
4 - Completely remove each of the
cheek pads from the inside by sliding
them onto each end of the chinstrap
while turning the helmet over if
necessary.
22
22
A
REMOVING THE LINING
3
4
1 & 2 - Slide your hand underneath the
back of the comfort liner and pull it
towards you on both sides to release
the comfort liner from its two clip
fasteners.
1
2