Cleaning The Exhaust Filter; Winding Up The Power Cable - Dirt Devil Factory Mode D'emploi

5 After use

5.5 Cleaning the exhaust filter

ATTENTION:
The filter is washable, but it may not be
cleaned in dishwashers
machines. Also, do not use detergents or
brushes with hard bristles to clean the filter.
Let the filter dry for approx 24 hours at room
temperature after washing it. Only put it
back in place when it is completely dry.
21
22

5.6 Winding up the power cable

180°
23
time. Therefore, it is important to check it reg-
ularly and clean it if necessary.
or washing
aged, replace it immediately ( Chapter 7.1,
"Ordering spare parts").
To clean the exhaust filter, proceed as fol-
lows:
1. Switch the appliance off and pull the plug
2. Open the exhaust filter cover (Fig. 21).
3. Remove the exhaust filter (Fig. 22).
4. Rinse out the exhaust filter thoroughly with
5. Let the exhaust filter dry for approx.
6. Put the exhaust filter back into the exhaust
7. Close the exhaust filter cover again
1. Press down the front cable holder and ro-
2. Then wind the power cord around the front
The exhaust filter could get dirty after a
If you see that the exhaust filter is dam-
out of the socket.
running cold or hand-warm water.
24 hours at room temperature after wet
cleaning. Only put it back in place when it
is completely dry.
filter cover (Fig. 22).
(Fig. 21). You will feel and hear it snap into
place.
tate through 180° so that it is positioned as
shown (Fig. 23).
and back cable holders as shown
(Fig. 23).
29