Usb Interface; Infrared Interface - Cameo Multi PAR Manuel D'utilisation

5
DMX OutPut
Female, 3-pole XLR socket. Used to loop through the DMX signal to additional DMX devices.
6
inPut FOR FOOt PEDAl
Female, 5-pole XLR socket for connecting the optional CLMPARFOOT2 foot pedal. The socket delivers the
supply voltage for the foot pedal, so it must always be connected using a 5-pole DMX cable with all signals
connected.
7
MiCROPhOnE FOR MuSiC COntROl.
8

uSB intERFACE

Used for service purposes. Not usable by the user.
9
lightED lC DiSPlAY With 4 COntROl ButtOnS
See the following pages of the User Manual.
10
SChukO POWER OutlEtS 1 AnD 2
Separate power sockets, switchable via DMX, infrared remote control, and optional foot pedal, for powering
additional CAMEO lighting products. Make certain that the power consumption of the connected devices does
not exceed 3 amperes.
11
MOuntS 1 AnD 2
Moveable mount for mounting up to 2 additional lights, for example, the CAMEO CLMOVER1. The weight of
the lights to be mounted must not exceed 5 kg each.
IMPORTANT INFORMATION: When mounting one or two additional lights, make certain that the overall cons-
truction is not overweighted on one side (balanced distribution of weight) and that the maximum load of the
stand used is not exceeded! For mounting, please use only the included mounting bolts.
12
POWER CORD FOR lightS 1 – 4.
13
ADjuSting SCREWS
Using the adjusting screws A and B, each of the 4 lights can be adjusted separately both horizontally and
vertically.
14

inFRARED intERFACE

In "IR ACTIVE" mode, this interface on the front of the multi PAR lighting system is used to control the unit
with the included infrared remote control. Make certain that there is a direct line of sight between the infra-
red interface of the remote control and the infrared interface of the multi PAR lighting system.
15
inDiCAtOR lED
As soon as a control command is given via the IR remote control, the indicator LED flashes.
COntROlS AnD DiSPlAY:
9