Maintenance/Servicing; Disposal/Recycling - Eaton CROUSE-HINDS Série Mode D'emploi

7

Maintenance/Servicing

The relevant national regulations which apply
to the maintenance/servicing of electrical
apparatus in explosive atmospheres, shall be
observed (IEC/EN 60079-17).
Before opening the enclosure, make sure that
the device is disconnected from the voltage,
or take appropriate protective measures.
The required maintenance intervals depend on
the specific application and will therefore have to
be determined by the user dependent on the
conditions of use.
When servicing the plugs and sockets, parti-
cularly those parts that are decisive for their type
of protection against explosion will have to be
checked (e. g. intactness of flameproof enclosed
components, of the housing, firm fit of the cable
entries and efficacy of gaskets).
If during servicing, repairs prove to be necessary,
section 8 of these operating instructions will have
to be observed.
8
Explosion protected plug 63 A, GHG 534
8 Repair/Overhaul/
Modifications
Repairs and overhaul may only be carried out
with genuine COOPER CROUSE-HINDS spare
parts.
Should the flameproof enclosure be dam-
aged, only a replacement will be permitted. In
case of doubt, the respective apparatus will
have to be returned to COOPER CROUSE-
HINDS for repair.
Repairs that affect the explosion protection,
may only be carried out by COOPER
CROUSE-HINDS or a qualified electrician in
compliance with the applicable national rules
(IEC/EN 60079-19).
Modifications to the device or changes of its
design are not permitted.
9

Disposal/Recycling

When the apparatus is disposed of, the respec-
tive national regulations on waste disposal will
have to be observed.
In order to facilitate the recycling of individual
components, plastic parts are provided with the
identification mark of the plastic material used.
Subject to modifications or supplement of the
product range.
GB