Attendant Control Panel (Acp) - arjo Enterprise 9600X Notice D'utilisation

Attendant Control Panel (ACP)

Attendant Control Panels are located on the outside panels of
both foot end split side rails. The ACP on the left side and right
side of the bed have different button layouts.
Fig. 26 - Attendant Control Panel (patient's right hand side)
Power on indicator - lights when the bed is connected to the
electricity supply.
Battery indicator - refer to the section "Backup battery" on
page 41.
Anti-Entrapment System (AES) indicator - refer to the section
"Anti-entrapment system" on page 50.
Mattress These buttons raise and lower the mattress platform.
platform height
All sections will lower at maximum speed until the bed reaches low
height (40cm*) where it will continue to lower at half speed until it
has reached extra low height (32cm*).
(*Low height and extra low height dimensions are for reference only.)
WARNING
Before lowering the bed, make sure that the space between the
mattress frame and chassis is free of persons, limbs, bedding or other
objects.
To avoid potential damage or injury, do not leave oxygen bottle or any
other obstacles under the bed frame while operated.
WARNING
At minimum height, clearance underneath the bed is reduced. Keep
your feet away from the areas below the split side rails and take extra
care when using patient hoists or similar equipment.
38
NOTE
The mattress platform will not lower to extra low height if the bed
platform is tilted (in Trendelenburg or reversed Trendelenburg
position).