No Operation Off (Av Mode Only); Power Management (Pc Mode Only); Image Position Adjustment (Av Mode Only); Automatic Image Position And Clock Adjustments (Pc Mode Only) - Pioneer PDP-5060HD Mode D'emploi

Adjustments and Settings

No Operation off (AV mode only)

The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "No Operation off". ( /
4
Select "Enable". ( / then ENTER)
Item Description
Does not place the system into the standby mode.
Disable
(factory default)
Enable Places the system into the standby mode if no
operation is performed for three hours.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.

Power Management (PC mode only)

The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "Power Management". ( /
4
Select "Mode1" or "Mode2". ( /
Item Description
No power management
Off
(factory default)
• Places the system into the standby mode when no
Mode1
signal is received from the personal computer for
eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
the remote control unit.
Mode2 • Places the system into the standby mode when no
signal is received for eight seconds.
• When you start using the computer and a signal is
received again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
the remote control unit.
5
Press HOME MENU to exit the menu.
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)
on
on
Image position adjustment
(AV mode only)
Adjusts the horizontal and vertical positions of images on the
Plasma Display.
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "Position". ( / then ENTER)
4
Select "H/V Position Adjust". ( /
Position
H/V Position Adjust
Reset
5
Adjust the vertical position ( / ) or horizontal position
( / ).
6
Press HOME MENU to exit the menu.
NOTE
• To restore the factory defaults for all the items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
• Adjustments are stored separately for each input source.
Automatic image position and clock
adjustments (PC mode only)
Use Auto Setup to automatically adjust positions and clock of
images coming from a personal computer.
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "Auto Setup". ( /
Option
Auto Setup
Manual Setup
• Auto Setup starts.
4
Press HOME MENU to exit the menu.
NOTE
• When Auto Setup is finished, "Auto Setup completed."
appears.
• Even when "Auto Setup completed." appears, Auto Setup
may have failed, depending on conditions.
• Auto Setup may fail with a PC image composed of similar
patterns or monochrome. If not successful, change the PC
image and try again.
• Be sure to connect the computer to the Media Receiver and
switch it on before starting Auto Setup.
then ENTER)
/ to
/ to select "Yes", and
then ENTER)
11
63
En