Garland DONKEY 693 R Manuel D'instructions page 47

6.2.5. HANDLEBAR COVER ASSEMBLY
Select two M6*16 screws and two M6 nuts
Place the cover as seen in the image, matching the
holes. Then insert the screws and screw the nuts
firmly on the opposite side.
6.2.6. ASSEMBLY OF THE TRANSPORT WHEEL
Place the machine horizontally resting on the
cutters and pull. Align the wheel holes with the front
protrusion of the frame.
Then insert the screw and bolt. Secure them at the
back with the corresponding clip and nut.
47/152
English