Garland DONKEY 693 R Manuel D'instructions page 46

English
Insert the pin through the indicated hole and through
the other side into the hole in the other plate.
Place the two plates as seen in the image and then
screw the nut lightly, do not tighten it completely since
we want it to have play for mounting the fender.
Now take the adjustable draft and connect the two
parts of it with the corresponding bolt and clip.
Then connect it to the machine using the long bolt you
see in the image and its corresponding clip.
Adjust the draft by unscrewing the nut from the two
side screws and inserting them into the retaining
plate.
6.2.4. INSTALLING THE HIGH AIR FILTER
Select two curved plates and four M6*16 screws, take
two of them and screw them onto the filter and the
plates lightly. Then place the filter on the handlebar
bar, holding it with the plates. Once positioned to your
liking, screw in the two remaining screws and tighten
all four firmly.
46/152