Handlebar Assembly - Garland Donkey 693 R Manuel D'instructions

Take the bolt and the remaining clip and insert it into
the opening you see in the image, then secure it with
the clip using the needle-nose pliers.

6.2.2. HANDLEBAR ASSEMBLY

Select four M8*25 screws and insert them into their
corresponding holes. Then with the open-end wrench,
tighten them firmly.
Now take the handlebar, a long screw M16*150, a
Ø16 flat gasket, a Ø16 spring gasket and the locking
handle.
Place the handlebar on the bracket by aligning the
holes, then insert the M16*150 long screw.
On the other side, insert the Ø16 flat gasket, the Ø16
spring gasket and the locking handle, then turn it until
tight.
6.2.3. ASSEMBLY OF THE FENDER FASTENING
PLATES AND THE ADJUSTABLE THROW.
Select two support plates and one Ø8*40 pin. Insert
the pin through the hole in one of the plates.
45/152
English