Publicité
1. SAFETY INSTRUCTIONS
IMPORTANT
Save this manual properly and read carefully the following instructions before installing the UPS. Do
not operate this Zen-X Master before reading through all safety information and operating
instructions carefully. Installation and Wiring must be performed in accordance with the local
electrical laws and regulations. Installing and connecting the UPS in a way that does not comply with
accepted practices releases Infosec Communication SAS from any liability.
Transportation
Please transport the UPS system only in the original package to protect against shock and impact.
Preparation and good disposal of the device
1.
Condensation may occur if the UPS system is moved directly from cold to warm environment.
The UPS system must be completely dry before being installed. Please allow at least two hours
for the UPS system to acclimate its environment.
2.
Do not install the UPS system near water or in moist environments.
3.
Do not install the UPS system where it would be exposed to direct sunlight or near heater.
4.
Do not block air vents in the housing of UPS. The UPS must be installed in a location with good
ventilation. Ensure enough space on each side for ventilation.
5.
The mains outlet that supplies the UPS must be located near the UPS and be easily accessible.
6.
Install the UPS in a temperature and humidity-controlled room free of conductive interference.
7.
Disconnect the UPS from AC power and switch it off before cleaning with a damp cloth (no
cleaning products).
8.
Do not leave any recipients containing liquid on or near the UPS.
9.
Place cables in such a way that no one can step on or trip over them.
10. Prevent no fluids or other foreign objects from inside of the UPS system
Risk of electric shock
1. The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble this equipment
as it does not contain accessible components that can be repaired by users, fuse change excepted.
2. Caution -risk of electric shock. The battery circuit is not isolated from the input voltage. Hazardous
voltages may occur between the battery terminals and the ground. Before touching, please verify
that no voltage is present!
3. The UPS system operates with hazardous voltages. Repairs may be carried out only by qualified
maintenance personnel.
4. The utility power outlet must be near the equipment and be easily accessible. To isolate the UPS
from AC input and switch it off, remove the plug from the utility power outlet.
5. During use, always keep the inverter plugged into the mains to benefit from the protective
earthing.
6. The UPS has its own internal power supply (battery). There is a risk that output sockets may still
be live after the UPS has been disconnected from the mains power supply.
7. In an emergency situation, press the ON/OFF button for 2 seconds to switch off the UPS and
disconnect the unit from the AC power supply.
8. When the UPS is out of order, please refer to section: "trouble shooting" and call the hot line.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com Hot Line –
Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 12 24 AA 36 204 37
19
Publicité
