Troubleshooting Guide - BH FITNESS G260 Instructions De Montage Et Utilisation

REFERENCE TABLE: BMI
THIN= NORMAL+
<18,5 =18,5~24,9
TEST MEASUREMENTS:
FITNESS
This electronic device is equipped
with a recovery test function. This
offers you the advantage of being
able to measure how long it takes
your heart rate to recover after having
finished the exercise. After finishing
the exercise leave your hands on the
pulse sensors (R) and press the
"Fitness Test" button and this will
start a one minute countdown. Only
the Time and Pulse rate function
read-outs will remain displayed. The
electronic device will measure your
pulse rate during this minute. The
heart rate recovery time will be
displayed on the Heart rate line. If, at
any time during this minute, you
decide to abandon this test then
press the "Test" button and this will
take you back to the main screen.
When the minute is up, the electronic
device will work out the difference
and your fitness
displayed up on the screen: "F1, F2,...,
F5, F16; where F1 is the best (fitness
"Excellent") and F6 the worst (fitness
"Very Poor").
Pressing the TEST button will take
you back to the main screen, where
the functions will be in the same mode
as when the TEST began.
Your fitness rating is a guideline that
shows you how fast your heart
recovers after physical exertion. If you
exercise regularly then you will see
your fitness rating improve.
The TEST will not work if you do not
have both hands placed on the hand-
SLIGHTLY OVER
OVERWEIGHT WEIGHT
=25~30 <30
rating will
grip sensors (R) Fig3 after you have
stopped doing the exercise.
If the error code "E1" is shown on the
screen then this means that you do
not have
correctly on the hand-grip sensors (R).
If the error code "E2" appears on the
screen, this means that you have not
stopped exercising.
FITTING THE ELECTRONIC
MONITOR.-
Bring the monitor (1) to the handlebar
stem (4) Fig.7, connect the two
terminals (19/49) coming out of the
handlebar stem (4) and the monitor (1)
Fig.5.
Insert the
handlebar stem (4), as shown in Fig.5,
making sure not to pinch any of the
cables. Fit the bolts (3) along with the
flat washers, securely tighten.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function Works.
Solution:
a.-Make sure that the connection
cable is connected.
be
Problem: The monitor does not
switch on.
Solution:
a.- Check
connections.
b.-Check the cable connections for
the main post.
Avoid leaving the electronic monitor
in direct sunlight as
damage the liquid crystal display.
Similarly, do not expose it to water or
knocks.
13
your hands positioned
monitor (1)
the monitor
this might
onto the
cable