BH FITNESS G260 Instructions De Montage Et Utilisation page 50

If the pulse rate is above the target
value the monitor will give out warning
beeps and reduce
settings by one
seconds until it reaches the minimum
1. If the pulse rate still stays above the
target value for more than 30 seconds
the monitor will beep and stop in order
to protect the user.
To program time, distance, calories
and/or pulse rate, go through the
following procedure: Once the heart
rate program has been selected and
before pressing the START / STOP
key, press the MODE key to program
the time limit using the ▲/▼ keys.
Press MODE again to program the
distance. Press the MODE key one last
time to program the calories. Press
START / STOP to start the exercise.
Your hands must be placed on the
pulse sensors (R) when using these
programs.
HAND-GRIP (PULSE)
INSTRUCTIONS/USE
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig 3. When
both hands are placed on the sensors
the heart symbol on the right-hand
side of the screen, marked PULSE,
will begin to flash and after a few
seconds a heart rate reading will be
displayed. If both hands are not
placed correctly
function will not work.
If a "P" appears on the screen or the
heart symbol does not flash then
make sure that both hands are placed
on the sensors
connectors are connected at the back
of the electronic unit.
the exertion
level every 15
then the pulse
and that the
TELEMETRIC PULSE RATE
The monitor is equipped to receive
signals from
measurement system.
The system comprises of a receiver
and a transmitter (chest band T) Fig 4.
This telemetric pulse rate system
takes precedence over the Hand-
grip pulse rate system when both
are used together.
See telemetric pulse rate instruction
book).
BODY FAT PROGRAM.-
This program is designed to calculate
the user's body fat percentage and
then create specific load profiles.
Press the BODYFAT key and place
your hands on the pulse sensors (R)
(Hand-grips), as shown in Fig 3. The
selected user (U1~U4) will blink for 2
seconds, the LCD will display "-- --"
and after a few seconds the lower
screens on the display will show your
FAT%; BMI (Body Mass Index).
If the error code "E-1" appears then
this means
occurred,
correctly on the pulse sensors (R),
Fig 3.
"E-2" means that data is out of range.
Press BODYFAT again to exit this
function.
REFERENCE TABLE: BODY FAT
PERCENTAGE %
SEX / LOW
FAT%
MALE <
13%
FEMALE <23%
12
a telemetric
that an error
position your
LOW / AVERAGE
AVERAGE
13%- 26%-30%
25,8%
23%- 36%-40%
35,8%
pulse
has
hands
HIGH
>30%
>40%