Advancing the Line Using the Bump Feed
1.
Run the trimmer at full throttle.
2.
Tap the bump button on the ground to advance the line. The line
advances each time the bump button is tapped. Do not hold the
bump button on the ground.
Note:
The line trimming cut-off blade on the grass deflector cuts the
line to the correct length.
Note:
If the line is worn too short, you may not be able to advance
the line by tapping it on the ground. If so, release the trigger and
refer to
Advancing the Line Manually (page
1. Bump button
Advancing the Line Manually
Remove the battery pack from the trimmer, then push the bump button at
the base of the spool retainer while pulling on the trimmer line to manually
advance the line.
Figure 9
18
18).
g331007